广州轨道交通三号线高速行驶条件下对安全限界的影响研究

给出了轨道交通车辆横向偏移量的计算方法 ,并应用列车 -线路动力耦合模型 ,分析了广州地铁三号线的安全限界变化问题。确定了当前按 80km/h行车速度设计的建筑限界能满足 13 0km/h行车速度的要求 ,限界尺寸不需改动可保证列车运行安全平稳     

Influence of floc dynamic protection layer on alleviating ultrafiltration membrane fouling induced by humic substances

Cake layer formation is inevitable over time for ultrafiltration (UF) membrane-based drinking water treatment. Although the cake layer is always considered to cause membrane fouling, it can also act as a “dynamic protection layer”, as it further adsorbs pollutants and dramatically reduces their chance of getting to the membrane surface. Here, the UF membrane fouling performance was investigated with pre-deposited loose flocs in the presence of humic acid (HA). The results showed that the floc dynamic protection layer played an important role in removing HA. The higher the solution pH, the more negative the floc charge, resulting in lower HA removal efficiency due to the electrostatic repulsion and large pore size of the floc layer. With decreasing solution pH, a positively charged floc dynamic protection layer was formed, and more HA molecules were adsorbed. The potential reasons were ascribed to the smaller floc size, greater positive charge, and higher roughness of the floc layer. However, similar membrane fouling performance was also observed for the negative and positive floc dynamic protection layers due to their strong looseness characteristics. In addition, the molecular weight (MW) distribution of HA also played an important role in UF membrane fouling behavior. For the small MW HA molecules, the chance of forming a loose cake layer was high with a negatively charged floc dynamic protection layer, while for the large MW HA molecules it was high with a positively charged floc dynamic protection layer. As a result, slight UF membrane fouling was induced.     

非饱和带强化反应层脱氮的试验研究

自然堆肥过程中,畜禽养殖产生的粪污渗滤液入渗土壤非饱和带.高浓度有机氮在微生物作用下经由复杂的地球化学过程转化为各种含氮物质,其中硝酸盐迁移能力较强,在降雨条件下入渗地下水,造成区域性地下水硝酸盐污染.在非饱和带中构建由木屑和壤土组成的强化反应层,通过间歇性的原位淋溶脱氮试验,系统地研究了非饱和带含水量及COD、硝态氮、亚硝态氮和氨氮的浓度变化规律,评价了强化反应层的脱氮能力.研究结果表明:①反应层中木屑材料的强吸水特性使得灌水后短时间内反应层含水量大幅提升,形成有利于反硝化进行的厌氧环境.木屑通过水解作用释放大量溶解性有机碳,供给反硝化微生物进行脱氮.②在入渗硝态氮浓度为170.00 mg·L~(-1)条件下,反应层对硝态氮去除率最高可达97.63%.反应层脱氮量随处理水量增加而提升,当上层为砂土时脱氮量最高,可达24.61 g·m~(-3).③反应层中的NO~-_3-N发生了完全反硝化,出水中NO~-_2-N浓度低于0.5 mg·L~(-1),几乎不发生积累.同时,反应层中发生的DNRA过程使氨氮浓度小幅升高.强化脱氮反应层可阻控硝酸盐污染地下水.     

基于空间适宜性评价和人口承载力的贵溪市中心城区城市开发边界的划定

城市开发边界的划定能够合理引导城市空间的有序发展,控制其无序蔓延。论文以典型的资源型城市贵溪市为研究区,从空间适宜性评价、人口承载力、城市规模以及城市总体规划和土地利用总体规划（简称“两规”）衔接等方面探索有效的城市开发边界划定方法。空间适宜性评价综合考虑自然、空间可达性和生态条件,运用聚类分析法确定区域内不宜作为开发建设的生态底线区域和适宜建设开发区域的高低等级,以此确定城市开发边界的发展方向。通过灰色预测GM(1,1)模型预测研究区2020年人口总量,并基于土地资源和水资源承载力验证当地所能容纳的最大人口总量,同时确定城市规模和划定城市开发边界。以空间适宜性评价、人口承载力、城市规模预测、两规衔接和空间形态控制等方法倒逼缩减建设用地,从而划定城市发展的刚性和弹性增长边界。     

颗粒物分界层Mie散射激光雷达识别的sigmoid算法

基于成都市2013年6月~2015年5月期间由Mie散射激光雷达探测的大气消光系数廓线资料,发现混合层以上在颗粒物消光和分子消光之间一致存在一个S型的过渡区,利用sigmoid函数对此分布形态进行模拟,通过计算该函数上下曲率最大点所在的高度,据此提出了颗粒物分界层Mie散射激光雷达识别的sigmoid算法.针对该算法模拟效果的分析表明,颗粒物分界层过渡区附近大气消光系数理论廓线和实测廓线保持了高度的相关性,二者在春夏秋冬四季的相关系数（R）分别为0.9971±0.0052、0.9935±0.0167、0.9979±0.0038和0.9990±0.0021（均通过α=0.05的显著性检验）.基于sigmoid算法计算的颗粒物分界层过渡区与成都市温江站探空资料得到的逆温层之间存在很好的对应关系.     

考虑边界条件不确定性的地下水污染风险分析

为分析边界条件不确定性对地下水污染质运移数值模拟模型输出结果的影响,运用Monte Carlo方法对一算例进行阐明,并从污染风险预报方面对模拟结果进行分析.为减少重复调用模拟模型产生的大量计算负荷,将边界条件（第一类边界条件-水头值）作为随机变量,建立地下水污染质运移数值模拟模型的Kriging替代模型,在保证较高精度的同时,实现了Monte Carlo模拟.结果表明：边界条件的不确定性,对地下水污染质运移数值模拟模型预报的结果有很大影响,考虑与未考虑边界条件不确定性得到的研究区污染羽分布差别较大.对地下水污染质运移数值模拟模型的Monte Carlo模拟结果进行统计与分析,可以评估研究区观测井1,2,3污染物浓度预报结果的可靠程度,并且可以预报出研究区观测井1,2,3遭受不同程度污染的风险.     

7B04铝合金和30CrMnSiA钢短期腐蚀的电化学行为研究

目的研究7B04铝合金和30CrMnSiA合金钢试样的电化学性能。方法采用电化学实验、扫描电子显微镜(SEM)、腐蚀坑深度测试分别对7B04铝合金和30CrMnSiA合金钢试样在是否经过天然海水浸泡的情况下进行测试分析,得到微观腐蚀形貌和腐蚀坑深度以及试样表面不带锈和带锈时的电化学性能。结果随着Na Cl浓度增大,7B04铝合金和30CrMnSiA钢的自腐蚀电流变大,两者之间存在明显的电位差,接触后会发生电偶腐蚀。电偶电流与阴阳极面积比和Na Cl浓度有关,阴阳极面积比增大或Na Cl浓度升高均会导致电偶效应增强。经过海水短期浸泡后,7B04铝合金表面的锈层不仅没有起到抑制腐蚀的作用,反而使自腐蚀加重,但电偶效应确实有所减弱。结论沿海设备在使用过程中应竭力避免铝合金在锈层下工作。     

一种模拟动力学边界条件的环境振动试验方法研究

目的提高环境振动试验的可靠性。方法以某典型钛合金蜂窝夹芯壁板试验件为例,提出一种模拟试验件动力学边界条件的试验方法,在试验件周围引入弹性连接件,再通过刚性转接工装与振动台台面连接,以试验件在试验安装状态下的共振频率及振型节线位置为优化目标,以弹性连接件的外形尺寸及厚度为优化变量,对弹性连接件进行优化设计,从而模拟试验件真实的动力学边界条件。结果弹性连接件的优化设计使得试验件在试验安装状态下前两阶共振频率与试验要求相差小于8%,而且振型节线位置与试验要求基本重合,达到了模拟试验件真实动力学边界条件的设计目标。结论对于壁板类试验件,在传统刚性夹具的基础上引入弹性连接件的试验方法,可以较好地模拟试验件真实动力学边界条件,提高环境振动试验的可靠性,并且这种方法对试验费用及试验周期影响较小,具有良好的工程应用前景。     

厂界噪声测量中若干问题探讨

在工业企业厂界噪声测量中经常遇到的问题主要有监测点位布设和背景噪声扣除两类,并对敏感点距声源距离与布点监测、背景噪声的测量和受外来声源严重影响时如何测量厂界噪声等问题提出了解决办法.     

Application of CFD Methods for Modelling in Air Pollution Problems: Possibilities and Gaps

Different urban air pollution problems deal with complex structure of air flows and turbulence. For such problems the Computer Fluid Dynamics (CFD) methods become widely used. However, this approach despite a number of advantages has some problems. Experience of use of CFD tools for development of models and suggestions of their applications for a local scale air pollution over a complex terrain and stable stratification are discussed in this paper, including: Topography and complex geometry: choose of the co-ordinate system and computer grid; Turbulence closure for air pollution modelling: modified k- model for stable stratified ABL; Boundary conditions for vertical profiles of velocity for stable-stratified atmosphere; Effects of the radiation and thermal budget of inclined surfaces to dispersion of pollutants; Artificial sources of air dynamics and circulation.Some examples of CFD applications for air pollution modelling for a flat terrain, mountainous area, mining open cast and indoor ventilation are discussed. Modified k- model for stably-stratified ABL is suggested. Due to the isotropic character of the k- model a combination of it in vertical with the sub-grid turbulence closure in horizontal can be more suitable for ABL. An effective scheme of boundary conditions for velocity profiles, based on the developed similarity theory for stable-stratified ABL, is suggested. Alongside with the common studies of atmospheric dispersion, the CFD methods have also demonstrated a good potential for studying anthropogenic and artificial-ventilation sources of air dynamic and circulation in local-scale processes of air pollution.